Sassafras mold after pour #9

Mistake: Using the concave lid mean that the eoxxy flowed under the baririer witout ceasing. I did try holding it down with a block, but the surface wasn't falt. So the result was not a final result.

Sass 9, initial pour

I had made a bend in the mold and the epoxy flowed where it wanted to. So I trimmed this up, put it back inside the mold and added another layer.

Sass 9, 2nd layer

GGot a little carried away on this one. Two pours -- the first with a loop inside using that same mold. I had had in mind to simply keep the part on the left, but too much had gotten past the barrier. So I pulled out the mold and settle around the "failed" one. This time a lot of red/oragne/yellow filling that channel was essentially impossible. Epoxy wants to flow and flowed right under.